ProductStock i-Valve Lift Controller
Stock i-Valve Lift ControllerDMG
In Stock
Lead Time 1-2 weeks
We hold in stock Hydraulic Lift Controllers to suit the Bucher i-Valve Pump Unit up to 22 kW with a maximum of 40 Amp Contactors. Out of the box the controllers are setup to suit a Bucher iCon Parameter Card, 240 VAC Door Operator and 110 V DC retiring cam.
These stock base units are then modified to suit your specific site requirements by our skilled technicians.
NB: The Bucher iCon and ParamCard are not included as standard but are available as an optional extra.
Standard Features
The DMG PB3 Controller is a 32-Bit Microprocessor Controller with many advanced features as standard
3 phase supply
2 to 8 floors
SAPB or Down Collective operation
Set for a 110 VDC Retiring Ramp voltage
24 hour battery test
4 point safety chain
Photocell input NO/NC
Floor level indication
Motor thermistor input
Auto shaft learn
Over 50 faults detected
Last 60 faults logged
Visual I/O status
Star Delta starting
Simplex control
Set for 1 x 240 VAC Car Door Operator
One position fire recall
Timed car lights off
Full load bypass and lift overload control
Out of service
Short floor capability
Programmable return zones (Weeks, Days, Hours, Minutes)
Selective or Simultaneous door control
Programming module with LCD screen with every panel
Programmable 4 digit code for car call acceptance
Advance door opening
Customisation Options
Our skilled Technical Engineers can carry out the following modification to the stock controller to match your project.
Single phase supply
Floors 9 to 16
Full collective operation
Customisation of the Retiring Ramp voltage to suit site conditions
Controller set for up to 2 x 3 phase Car Door Operators
16 way output card to drive existing displays
The addition of resistors for DC Door Operators (GAL, DUPAR or H&C)
Direct Online or Soft start
Duplex/Triplex/Quadraplex control
Controller set for 2 x 240 VAC Door Operators (Side A & B)
BMS interface
4 position fire recall
Overspeed Governor trip and/or Reset
A3 Control
Shaft Kit
A Hard Wired Shaft Kit is included with every controller, the elements of each kit will depend on the type of lift.
For more information, please contact a member of our Lift Components Team.
For more information, please contact a member of our Lift Components Team.
Encoder Counting Kit & Rope 60/120m
Emergency Operation Box
Door Zone Kit
Magnets/Support Bracket Kit (Door Zone)
Relevelling and Door Zone Kit
Magnets/Support Bracket Kits (Relevelling)
Final Limit Switch Kit (Traction/Hydraulic Direct)
Final Limit Switch Kit (Traction/Hydraulic Indirect)
Final Limit Switch Support Kit
H Supports
Magnetic Deceleration Switches
